Max SN883CH/34 Specifiche

SN883RH, SN883CH/34,SN883CH/28PNEUMATIC NAILERBEFORE USING THIS TOOL, STUDY THIS MANUAL TO ENSURE SAFETY WARNINGAND INSTRUCTIONS.KEEP THESE INSTRUCTIO

10WARNING:WARNING:4. INSTRUCTIONS FOR OPERATIONRead section titled “SAFETY INSTRUCTIONS”.1. BEFORE OPERATIONqWear Safety Glasses or Goggles.wDo not co

11TEST OPERATIONqAdjust the air pressure at 70 p.s.i. (5 bar) and connect the air supply.wWithout touching the trigger, depress the contact arm agains

12wRemove the Switching Lever to the direction of the arrow.NOTE:When switching back CONTACT ACTUATION with ANTI-DOUBLE FIRE MECHANISM to SINGLEACTUAT

21PROCEDUREqHold the Trigger.wDepress the Contact Arm.CONTACT TRIP MODEL with ANTI-DOUBLE FIRE MECHANISMThe anti-double fire mechanism (US patent 5597

14PROCEDURECONTACT TRIP WITH ANTI-DOUBLE FIRE MECHANISM(US patent 5597106, UK patent 2286790)Identified by RED TRIGGER.The Switching Lever is removed.

CONTACT TIP (OPTION)ALWAYS disconnect air supply before attaching / detaching the Contact Tip.Attach the Contact Tip on the tip of Contact Arm “B”, wh

16REMOVING JAMMED NAILSALWAYS disconnect air supply before removing jammed nails.WARNING:ePull and stayed the Pusher back using the hole and a rod.rRe

5. MAINTAIN FOR PERFORMANCEqDO NOT FIRE THE NAILER WHEN IT IS EMPTYwUSE A 3-PIECE AIRSETFailure to use a 3-piece airset allows the moisture and dirt i

• The content of this manual might be changed without notice for improvement.Recycled paper is used for this manual and its recyclable.〔〕6-6 NIHONBASH

2DEFINITIONS OF SIGNAL WORDSWARNING: Indicates a potentially hazardous situation which, if not avoided, couldresult in death or serious injury.CAUTION

3ENGLISHSN883RH, SN883CH/34,SN883CH/28PNEUMATIC NAILERBEFORE USING THIS TOOL, STUDY THIS MANUAL TO ENSURE SAFETY WARNINGAND INSTRUCTIONS.KEEP THESE IN

41. SAFETY INSTRUCTIONSPRECAUTIONS ON USING THE TOOL1. WEAR SAFETY GLASSES OR GOGGLESDanger to the eyes always exists due to the possibility of dust b

58. INSPECT SCREW TIGHTNESSLoose or improperly installed screws or bolts cause accidents and tool damage when the tool is putinto operation. Inspect t

618. WHEN USING THE TOOL OUTSIDE OR ELEVATED PLACEWhen fastening roofs or similar slanted surface, start fastening at the lower part and gradually wor

72. SPECIFICATIONS AND TECHNICAL DATA1. NAME OF PARTSqFramewCylinder CapeContact ArmrNosetMagazineyTriggeruGripiExhaust CoveroPusher!0Adjustment Diali

84. TECHNICAL DATAqNOISEA-weighted single-event sound power level ------ LWA, 1s, d 101.03 dBA-weighted single-event emission sound pressure level at

9WARNING:3. AIR SUPPLY AND CONNECTIONSRead section titled “SAFETY INSTRUCTIONS”.DO NOT USE ANY POWER SOURCE EXCEPT AN AIR COMPRESSORThe tool is design